Revision 1:
-----------

* Adjustable LCD contrast.
* Battery voltage is logged and displayed on the SAFE screen.
* Button and arming beeps can be turned off individually.
* Corrected the motor layout for 'DualCopter'. Rotation for M1 was incorrect.
* Customizable AUX switch functions.
* Fixed a bug (original FW) that forced you to go via the SAFE screen before mixer changes were reflected on the 'Show Motor Layout' screen.
* Flight mode replaced 'Self-level' on the SAFE screen and will indicate "ACRO", "SL MIX LOW/MED./HIGH" or "NORMAL SL".
* LED flashing in sync with the LVA (Low Voltage Alarm) beeps.
* No access to the Mixer Editor or the Show Motor Layout screen unless a motor layout is selected.
* The Lost Model Alarm will sound after 20 seconds (i.e. after the Auto Disarm countdown) if AUX switch pos. 1 is selected or if there is no AUX input.
* Usage warning and a disclaimer are displayed after a factory reset.


Revision 2:
-----------

* Multiple user profiles.
* Customizable AUX switch functions (now with 5 positions).
* The Confirmation dialogue now has a header ("CONFIRM") and is also more informative.
* A confirmation beep is produced when the AUX switch is moved to a new position.
* ESC throttle calibration is now a lot safer since it will require enabling through the KK2 menu before it can be accessed.
* Camera gimbal can now be tuned and tested without arming the KK2 controller.
* Added the "SL Mixing" parameter to the Stick Scaling screen. This adjusts the stick input sensitivity in "Mixed" mode.
* SL mixing rate is now configurable. The old modes correspond to a value of 5 (LOW), 10 (MEDIUM) and 20 (HIGH).
* LED will flash rapidly for a few seconds after arming if the Low Voltage Alarm value is set too low.
* The AUX switch no longer needs to be in position #1 to trigger the Lost Model Alarm after the Auto Disarm countdown.
* Replaced the "Calibrating ESCs..." text with "ESC CALIBRATION" to make it less confusing.
* Improved button handling on the main menu. Pushing button 4 (MENU) on the SAFE screen and holding it down for too long will no longer activate a menu item.
* Fixed a problem with the Lost Model Alarm. It was not trigged after the Auto Disarm countdown if the Alarm function was assigned to AUX position 1.
* Fixed a bug in the Number Editor (original firmware) that allowed setting a value to zero (CLR) when the lower limit was higher.
* Fixed a bug causing an error message ("Sensor calibration data out of limits") to be displayed after a factory reset.
* Fixed a bug in the original firmware that kept the "Link Roll Pitch" flag from being updated until the user returned to the SAFE screen.
* Fixed a bug that affected SL P-gain when switching from mixed to normal SL mode. SL P-gain remained on its previous value instead of being reloaded.
